SERVICE
FAQ
Q
Brake system fault light
A
When the light is on, there may be low brake fluid level, brake system failure, etc. The indicator also lights up when the handbrake is activated and goes out when released.
Q
The power indicator on the instrument panel is not on and the motor is running normally.
A
1 There is no voltage between the positive and negative leads of the dial: poor contact of the connector or open circuit of the lead: re-plug or change the wire;
2 Luminous tube damage: replace or repair the luminous tube;
3 There is an open circuit on the dial circuit board: replace or repair the instrument circuit board.
Q
The ride is laborious and slow
A
1 Check whether the brake is locked;
2 whether the inner tube pressure is appropriate;
Q
The oil gauge is not allowed, the remaining mileage is less than 350KM after filling up the oil, and the light will turn on after running about 100 kilometers.
A
According to personal analysis, when refueling, the oil gun injects oil to the rear of the car and directly impacts the oil float, causing the oil float to work abnormally. Find after-sales replacement of the oil float or reset the MCU; daily riding record the mileage after refueling.
Q
Leakage of coolant, smell of burning when riding and may see water vapor
A
Most of them leak at the hose plug near the radiator and thermostat because the hose hoop is too loose when leaving the factory. Tighten the hoop by yourself or change the stainless steel hoop.